Edelbrock

Edelbrock Camshaft Performer-Plus Hydraulic Roller Small Block Chevrolet 1987-Later w/ Thrust Plate

Part No.: 2209
Fitment: Special order — we confirm the lead time before it ships.

$625.95

4 interest-free payments or as low as $—/mo with Affirm. See if you qualify

In Stock

in stock

Compatibility

Vehicle-specific fitment: Review application details below
Need help?: Confirm fitment with us before ordering — (714) 202-7886

We list the engine platform a part is built for. That is not year-and-trim application data, so it does not confirm a fit on your specific vehicle.

Install quoted on request. We fit parts in-house in Huntington Beach, but we do not publish a labor figure for this item — we would rather quote your car than guess. Call (714) 202-7886 or pick Install at HRC and add your vehicle details, and we will come back with the labor.

Quantity:

Warranty & track disclaimer — read before you race it.
Shipping & returns — rates and RMA terms.
Installed in-house in Huntington Beach, CA — labor & service policy.
Affirm and PayPal available at checkout.

More ways to pay at checkout

Edelbrock Rollin' Thunder Camshaft #2209 is designed for 265-350 Chevy V8 engines from 1987-Later and produce optimum torque from the low-end to the mid-range. Rollin' Thunder camshafts should be matched with Performer manifolds for vehicles operating from off-idle to 5500 rpm. They are smooth idling cams for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. This cam produced 408HP and 450 Ft Lbs or Torque when paired with Pro-Flo XT EFI system #3528 and Performer RPM E-Tec cylinder heads #60975 on a 383 c.i.d. engine using stock hydraulic roller lifters and pushrods. Camshaft specifications: - Intake duration: 212 Degrees - Exhaust duration: 222 Degrees - Intake lift:.462" - Exhaust lift:.479" - Lobe separation: 112 Degree - Intake Center Line: 107 Degree - Vacuum: 16"

Edelbrock Rollin' Thunder Camshaft #2209 is designed.

Part No.	2209
Brand	Edelbrock

Commonly Needed With This

Parts builders usually buy alongside this one — gaskets, seals and hardware for the install. These are suggestions, not a verified fit: call (714) 202-7886 to confirm before ordering.