Edelbrock

Edelbrock Hydraulic Roller Camshaft for 1987 And Later Gen-I Small-Block Chevy

Part No.: 2207

$740.95

4 interest-free payments or as low as $—/mo with Affirm. See if you qualify

In Stock

in stock

Compatibility

Vehicle-specific fitment: Review application details below
Need help?: Confirm fitment with us before ordering — (714) 202-7886

We list the engine platform a part is built for. That is not year-and-trim application data, so it does not confirm a fit on your specific vehicle.

Install quoted on request. We fit parts in-house in Huntington Beach, but we do not publish a labor figure for this item — we would rather quote your car than guess. Call (714) 202-7886 or pick Install at HRC and add your vehicle details, and we will come back with the labor.

Quantity:

Warranty & track disclaimer — read before you race it.
Shipping & returns — rates and RMA terms.
Installed in-house in Huntington Beach, CA — labor & service policy.
Affirm and PayPal available at checkout.

More ways to pay at checkout

Edelbrock Rollin' Thunder Camshaft #2207 is designed for 283-400 V8 Chevy engines from 1987-Later and produces optimum torque from the low-end to the mid-range. Rollin' Thunder camshafts should be matched with Performer manifolds for vehicles operating from off-idle to 5500 rpm. They are smooth idling cams for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. This camshaft produced 460HP and 460 Ft Lbs of Torque when paired with Performer RPM Air-Gap intake manifold #7516, Thunder Series AVS carb #1813 and Performer RPM E-Tec cylinder heads #60985 on a 383 c.i.d. Small Block Chevy engine. Use with a high stall torque converter and stock ratio rocker arms only. Camshaft specifications: - Intake duration: 242 Degrees - Exhaust duration: 240 Degrees - Intake lift:.594" - Exhaust lift:.594" - Lobe separation: 112 Degree - Intake Center Line: 107 Degree - Vacuum: 11"

Edelbrock Rollin' Thunder Camshaft #2207 is designed.

Commonly Needed With This

Parts builders usually buy alongside this one — gaskets, seals and hardware for the install. These are suggestions, not a verified fit: call (714) 202-7886 to confirm before ordering.