1967-1969 Firebird Torque Arm Rear Suspension
4 interest-free payments or as low as $—/mo with Affirm. See if you qualify
Compatibility
- Vehicle-specific fitment
- Review application details below
- Need help?
- Confirm fitment with us before ordering — (714) 202-7886
We list the engine platform a part is built for. That is not year-and-trim application data, so it does not confirm a fit on your specific vehicle.
- Install quoted on request. We fit parts in-house in Huntington Beach, but we do not publish a labor figure for this item — we would rather quote your car than guess. Call (714) 202-7886 or pick Install at HRC and add your vehicle details, and we will come back with the labor.
- Warranty & track disclaimer — read before you race it.
- Shipping & returns — rates and RMA terms.
- Installed in-house in Huntington Beach, CA — labor & service policy.
- Affirm and PayPal available at checkout.
More ways to pay at checkout
TCI Engineering’s 1967-1969 Pontiac Firebird Torque Arm Rear Suspension assembly is engineered for Street, Autocross and Road Course Applications. The Torque Arm rear suspension was designed to eliminate the suspension bind that occurs when cornering using the stock conventional leaf spring suspension. The Torque Arm features a telescoping slider at the front of the arm that rotates as the car goes through suspension travel and articulation. This allows the cars handling to be controlled by the coil-over shocks and the rear sway bar with no suspension binding variables. The kit allows for a lowered stance, greater rear axle control and dramatically improved handling.
There are 3 height adjustments on the axle brackets in one inch increments. You also have the ability to fine tune the ride height further with the adjustable coilovers.
The installation mostly requires drilling and bolting in components. The 1967-1969 Pontiac Firebird Torque Arm kit is a bolt on application except for welding the axle brackets, panhard bracket, Torque Arm tabs and optional sway bar brackets onto the axle housing. We provide detailed instructions to properly attach the axle brackets and a fixture for the Torque Arm tabs. The optional anti-sway bar will require brackets to be welded onto the axle housing as well. The kit is available for any housing utilizing 3″ axle tubes. Complete 9” axle housings are available fully welded and ready to be bolted in.
All TCI Engineering products come with our Dual Warranty. 6 Year, 60,000 Mile Warranty on wear and tear items like bushings, coil-overs, & ball joints. Any items built in house by TCI Engineering such as link bars, control arms, spindles, crossmembers, etc come with a Lifetime Warranty.
Also fits: 1967-1969 Camaro
| Part No. | TCI-529-5105-00 |
|---|---|
| Brand | Total Cost Involved |
Platform-level fitment (Ford + GM, Phase 1). We publish the engine platform a part is built for — not year-and-trim application data — so nothing here confirms a fit on a specific vehicle. Confirm fitment with us before ordering: (714) 202-7886.
Commonly Needed With This
Parts builders usually buy alongside this one — gaskets, seals and hardware for the install. These are suggestions, not a verified fit: call (714) 202-7886 to confirm before ordering.
